whosits whatsits thingys that go wheresits?

[holeski]

Engine transmission alignment dows. The two that are on the block and fit into the bell housing. What is their real name and where can I find some? Napa says no such thing. :yawn: I know you can run with out them but they are what index the tranny & motor and I rather have them then just the bolts.

[Jackrabbit]

Aren't they just roll pins?

[akjeep]

Ya gotta measure the diam and get roundstock and make your own.
Period.
Dealer only item, and I'm gonna wager you are talkin' AMC.

[wagonburner]

or you could check www.advanceadapters.com/ they might have something

[holeski]

J4005148 Jeep part number. $6.00 each non in the State. And it takes to long to get here.

[holeski]

Aren't they just roll pins?

Yes they are but Where would I find some that are as large as these are. It's for my YJ.

[akdsmer]

Why don't you try the two machine shops in town?

Northern...452-2004
Ports....too lazy to look that # up, plus I always deal with the guys at Northern!

[holeski]

I did non in the size I needed.

[akdsmer]

You also might try Sentry hardware.

[ChevyKev]

I did non in the size I needed.

Dare I say, "Use a micrometer to measure your dowell!" :eek:

[holeski]

Dare I say, "Use a micrometer to measure your dowell!" :eek:

I did why?

OD .560
ID .450
legnth .800
:p

[holeski]

Well I just reshaped the old ones. They pressed in the block fine just hope the bellhousing fit good too.