+- Arctic Offroad Forums (http://www.arcticoffroad.com)
+-- Forum: Talk (http://www.arcticoffroad.com/forumdisplay.php?fid=3)
+--- Forum: General 4X4 (http://www.arcticoffroad.com/forumdisplay.php?fid=9)
+--- Thread: whosits whatsits thingys that go wheresits? (/showthread.php?tid=734)
whosits whatsits thingys that go wheresits? - holeski - 08 Aug 06
Engine transmission alignment dows. The two that are on the block and fit into the bell housing. What is their real name and where can I find some? Napa says no such thing. :yawn: I know you can run with out them but they are what index the tranny & motor and I rather have them then just the bolts.
whosits whatsits thingys that go wheresits? - Jackrabbit - 08 Aug 06
Aren't they just roll pins?
whosits whatsits thingys that go wheresits? - akjeep - 09 Aug 06
Ya gotta measure the diam and get roundstock and make your own.
Period.
Dealer only item, and I'm gonna wager you are talkin' AMC.
whosits whatsits thingys that go wheresits? - wagonburner - 09 Aug 06
or you could check www.advanceadapters.com/ they might have something
whosits whatsits thingys that go wheresits? - holeski - 09 Aug 06
J4005148 Jeep part number. $6.00 each non in the State. And it takes to long to get here.
whosits whatsits thingys that go wheresits? - holeski - 09 Aug 06
Jackrabbit Wrote:Aren't they just roll pins?
Yes they are but Where would I find some that are as large as these are. It's for my YJ.
whosits whatsits thingys that go wheresits? - akdsmer - 09 Aug 06
Why don't you try the two machine shops in town?
Northern...452-2004
Ports....too lazy to look that # up, plus I always deal with the guys at Northern!
whosits whatsits thingys that go wheresits? - holeski - 09 Aug 06
I did non in the size I needed.
whosits whatsits thingys that go wheresits? - akdsmer - 09 Aug 06
You also might try Sentry hardware.
whosits whatsits thingys that go wheresits? - ChevyKev - 09 Aug 06
holeski Wrote:I did non in the size I needed.
Dare I say,
"Use a micrometer to measure your dowell!" :eek:
whosits whatsits thingys that go wheresits? - holeski - 09 Aug 06
ChevyKev Wrote:Dare I say,I did why?
OD .560
ID .450
legnth .800
:p
whosits whatsits thingys that go wheresits? - holeski - 10 Aug 06
Well I just reshaped the old ones. They pressed in the block fine just hope the bellhousing fit good too.