27 Mar 11, 10:58 pm
a level headed dodge. Two inch leveling kit and new front shocks installed. Just a DD but an update/mod.
This was actually a bit difficult -
being I did it outside with a floor jack, hand tools, wood blocks, cinder blocks and a 3" ratchet strap. It was wet and cold and dark The goal was to fit 35 inch tires on, except the 2003 dodge will not allow for the 16" OR 16.5" wheels I had. So... I cant sell my current 17 inch wheels and tires to fund a plasma cutter.
sigh...
The goal was to increase the tire height to get better highway miles due to a better ratio. (same RPM, but at a higher speed)
ill have to save up for when these tires go bald. Thinking about 38 inch swampers in the near future for my 01 dodge after i spring the axle forward a few inches.
Tragdor is now sitting on blocks. the goal is to get the tractors and RCV shafts on them this weekend!
This was actually a bit difficult -
being I did it outside with a floor jack, hand tools, wood blocks, cinder blocks and a 3" ratchet strap. It was wet and cold and dark The goal was to fit 35 inch tires on, except the 2003 dodge will not allow for the 16" OR 16.5" wheels I had. So... I cant sell my current 17 inch wheels and tires to fund a plasma cutter.
sigh...
The goal was to increase the tire height to get better highway miles due to a better ratio. (same RPM, but at a higher speed)
ill have to save up for when these tires go bald. Thinking about 38 inch swampers in the near future for my 01 dodge after i spring the axle forward a few inches.
Tragdor is now sitting on blocks. the goal is to get the tractors and RCV shafts on them this weekend!