23 May 09, 11:35 pm
SAV - The welded 14FF is in. I broke a bolt in the pinion, so will change that tomorrow. Need to plum new brake lines and get a connector to bypass the brake/load valve.
After that, need to verify the front bearings are okay, and if they are tighten them up a bit, if not swap them for ones that are okay.
Also, fixed the dash lights, in the middle of swapping radios, and installing a CB.
After that, need to verify the front bearings are okay, and if they are tighten them up a bit, if not swap them for ones that are okay.
Also, fixed the dash lights, in the middle of swapping radios, and installing a CB.