30 Apr 07, 08:33 pm
Got the threads cut off of the York, need to go out and get some drill bits, find a 1/2" NPT (it will work Kelly, I think. There's alot of meat to drill through. The hole to tap is just under 3/4") and a couple of fittings from Alaska rubber.
After I get it all assembled, I'll lay out the parts, find out where to put the manifold (already have a good idea), cut the tubing and test it out. I'll probably have this thing installed by the end of the week.
After I get it all assembled, I'll lay out the parts, find out where to put the manifold (already have a good idea), cut the tubing and test it out. I'll probably have this thing installed by the end of the week.