07 Nov 06, 04:24 pm
As for the Blazer:
33 mile loop ripped my rear brake line (when someone wasn't paying attention while lowering the ax;e from the springs... :whistle: ) So that needs to be done
Then rescuing a certain Jeep from a certain water hole, I then had to driove through it as well - soon after the temps dropped - no big deal, right? Well, now my hubs aren't engaging. I'm sure it's just water in there frezing them up - but I need to go through the front haxle hubs and clean and re-grease everything, as well as a probable fluid change.
Suburban's winterization needed a little attention - it should be good to go as soon as I get new battery pads.
Skitrzo's engine is ready to rip apart. While I have it in the garage I will re-install the trans/t-case, re-do the engine with a non-cracked block, go through the front axle and figure out what went wrong in there, and install a heater.
I currently have the 83 Cherokee in the garage as I have it sold. I need to replace the valve cover, the battery, and the front sway bar and driveshaft. May install the nerf bars as well. Anyone have spare stock sway bar connecting rods?
7.3 Ford diesel engine is under rebuild.
Raven's truck should be done tomorrow possibly.
Need to troubleshoot the 6.2 diesel 3+3 and get it started and gone.
33 mile loop ripped my rear brake line (when someone wasn't paying attention while lowering the ax;e from the springs... :whistle: ) So that needs to be done
Then rescuing a certain Jeep from a certain water hole, I then had to driove through it as well - soon after the temps dropped - no big deal, right? Well, now my hubs aren't engaging. I'm sure it's just water in there frezing them up - but I need to go through the front haxle hubs and clean and re-grease everything, as well as a probable fluid change.
Suburban's winterization needed a little attention - it should be good to go as soon as I get new battery pads.
Skitrzo's engine is ready to rip apart. While I have it in the garage I will re-install the trans/t-case, re-do the engine with a non-cracked block, go through the front axle and figure out what went wrong in there, and install a heater.
I currently have the 83 Cherokee in the garage as I have it sold. I need to replace the valve cover, the battery, and the front sway bar and driveshaft. May install the nerf bars as well. Anyone have spare stock sway bar connecting rods?
7.3 Ford diesel engine is under rebuild.
Raven's truck should be done tomorrow possibly.
Need to troubleshoot the 6.2 diesel 3+3 and get it started and gone.