13 May 06, 01:05 pm
I went to put the shocks on Monty's rear end today that 28this gave me. They are 2 inches longer than my stock ones, but the bottom bolt that attaches to my axle is too big to fit through the shock's bushing. Now what do i do?
I can't get the metal center out of the bushing to just slide the bolt thtrough it. So that doesn't seem to be a logical solution. If I use a smaller bolt, won't it "bounce" around inside the bracket on the axle?
I can't get the metal center out of the bushing to just slide the bolt thtrough it. So that doesn't seem to be a logical solution. If I use a smaller bolt, won't it "bounce" around inside the bracket on the axle?