Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
New guy
#1
Looking for a group to do some wheeling. Seen arctic off road around and would like to get involved.
Reply
#2
Welcome. Tell us about your Yota, and come on out to the next meeting.
Reply
#3
Welcome
Reply
#4
When and where is the meeting
Reply
#5
Welcome.
Next meeting will be at a Member's house (Mel) near the Fairbanks end of Badger....directions can be sent you or posted up, however Mel chooses.

Meeting Friday, June 6, around 6pm.
Formal agenda, but informal meeting.

We usually wheel a lot...a check of the gallery will show you that.
Lots coming up from quasi adventure wheeling to old mining roads.
Reply
#6
Great. See u guys next week
Reply
#7
Welcome to the site. Come on out next week, Mel will post some directions. So what kind of Yota? I see your picture shows a 90's truck.
Reply
#8
It's a 92 yota extra cab. Used to be my my wife's truck until the engine went south. Then made the decision to turn it into my trail truck. Gutted out All of the yota drive train and over a couple years installed all chevy drivetrain, one ton axles, t-case, turbo 400, and a 350 V8 plus a ton of little things (that's the short version)
Reply
#9
Its a 92 yota extra cab. Used to be my wife's truck until the engine went south. Then Decided to turn it into my trail truck. Gutted all the yota drive train and installed all chevy drivetrain, 350 V8, turbo 400 tranny, 208 tcase and one ton axles (that's the short version)
Reply
#10
88XJ Wrote:Welcome to the site. Come on out next week, Mel will post some directions. So what kind of Yota? I see your picture shows a 90's truck.

SAS it looks like with what may be D44's and chevy springs?
Reply
#11
Yeh just replaced that 44 with a 60. Kept breaking the 44
Reply
#12
Kozmo Wrote:Yeh just replaced that 44 with a 60. Kept breaking the 44

Still have the yota drive train 3.slow or 22R-E? Or Chevy 4.3?
Reply
#13
350 V8, turbo 400 tranny, 208 t-case
Reply
#14
Yup, you will fit right in.
Reply
#15
welcome Kozmo, this is a great group of people. and hopefully by the end of june i'll have my wheeler put together and finally get my runs in.
Reply
#16
Welcome. Directions will be in the June meeting thread.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)