30 May 09, 09:48 pm
(This post was last modified: 30 May 09, 10:04 pm by SamuraiMike.)
The PitBulls would be GREAT!!! I want to build the Zuk for that exact tire!!! 
The Sammi Build Plan:
2.7L All Aluminum V6 (183HP up from 68!)
Auto Tranny (till I find a 5 speed)
Dual Xfers (Toy 4.7 behind the front Suzuki, OTT mods it)
Lengthening the wheelbase (100"ish) to balance the front & rear, hopefully same length driveshafts
35” Pitbull Rockers (Building for 39.5s later)
3 link front & rear suspension set to ride LOW on air bags (10-14” travel 20% up/80% down)
Huge ground clearance, with low center of gravity and a flat belly pan
Fully adjustable ride height, raise 10” to cross water, or drop to bumpstops for North Pole Nazi frame measurement.
Toy Axles stuffed with Chromalloy shafts, Aussie front & Detroit rear
(I would upgrade to ECTED lockers if I had more coin)
Hyd ram assisted steering
Cadillac rear disk brakes
Finishing the front Exo & opening the wheelwells huge to fit 42” tires fully stuffed
Building “wing fenders” & my signature rubber mud flaps
Well, that's the build plan, but I sure could use the $5k and new tires!!! LOL!!!
Here's a concept Pic, minus bumpers and exo and about where the suspension would sit raised:
![[Image: samurai_pics_33.jpg_mod2.jpg]](http://www.arcticoffroad.com/forum/gallery/files/1/7/samurai_pics_33.jpg_mod2.jpg)
The Sammi Build Plan:
2.7L All Aluminum V6 (183HP up from 68!)
Auto Tranny (till I find a 5 speed)
Dual Xfers (Toy 4.7 behind the front Suzuki, OTT mods it)
Lengthening the wheelbase (100"ish) to balance the front & rear, hopefully same length driveshafts
35” Pitbull Rockers (Building for 39.5s later)
3 link front & rear suspension set to ride LOW on air bags (10-14” travel 20% up/80% down)
Huge ground clearance, with low center of gravity and a flat belly pan
Fully adjustable ride height, raise 10” to cross water, or drop to bumpstops for North Pole Nazi frame measurement.
Toy Axles stuffed with Chromalloy shafts, Aussie front & Detroit rear
(I would upgrade to ECTED lockers if I had more coin)
Hyd ram assisted steering
Cadillac rear disk brakes
Finishing the front Exo & opening the wheelwells huge to fit 42” tires fully stuffed
Building “wing fenders” & my signature rubber mud flaps
Well, that's the build plan, but I sure could use the $5k and new tires!!! LOL!!!
Here's a concept Pic, minus bumpers and exo and about where the suspension would sit raised:
![[-]](http://www.arcticoffroad.com/images/collapse.png)