cross over steering for dodge rams

[ak_petey]

So I have decided not to sell my dodge. I like it enough the way it is.
It would cost me more money to get a new vehicle in the long run anyway.
I have invested in spyntech manual hubs with 35 spline outers. These are very spendy. why take a hit and stop here?

My current pet peeve is the sloppy steering. the tie rod ends are BENDING. so I have been on a hunt for steering knuckles that would provide me the ability to add crossover steering, it is not the king pin knuckles like I wanted but Ive read up on ball joint vs king pin knuckles enough to decide that what I have is good enough, this truck will see the road 95% of the time and 5% off road. I can live with ball joints.

Spyntech, the home of solid axle industries... or the other way around has a high steer knuckle kit for my dodge. I am stoked about this. I got a small bonus that would cover this, I am ordering tomorrow! I will post up parts and install when I get items. .. Im excited!![COLOR="Silver"]

---------- Post added at 09:32 pm ---------- Previous post was at 09:28 pm ----------

[/COLOR]http://www.solidaxle.com/ProductCart/pc/...product=43
http://www.solidaxle.com/ProductCart/pc/...product=45[COLOR="Silver"]

---------- Post added at 09:36 pm ---------- Previous post was at 09:32 pm ----------

[/COLOR]well, I guess this is turning into a build thread. Can someone PM me directions on how to move it to the appropriate section?

here is a start of what I have done so far.