Arctic Offroad Forums › Talk › General 4X4 v
Shortening an axle

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Shortening an axle
TJVigilante
Guest
 
#12
09 May 07, 10:21 pm
My housing is 56.5" from end to end, so that housing that's loose should work out fine with the shafts I have...i think it measured at around 60" at the bearing retainer plate?

Everything online points me to that diff being a posi, except for the fact that it's got spider gears and a center pin block instead of clutch disks...perhaps the original owners opened it up and replaced the posi stuff with open spiders? Makes no sense.
Reply


Messages In This Thread
Shortening an axle - by TJVigilante - 07 May 07, 07:51 pm
Shortening an axle - by 78calico - 07 May 07, 10:39 pm
Shortening an axle - by TJVigilante - 07 May 07, 10:45 pm
Shortening an axle - by 78calico - 07 May 07, 10:46 pm
Shortening an axle - by 78calico - 07 May 07, 10:47 pm
Shortening an axle - by TJVigilante - 07 May 07, 10:47 pm
Shortening an axle - by 78calico - 07 May 07, 10:53 pm
Shortening an axle - by mousee - 09 May 07, 01:18 pm
Shortening an axle - by TJVigilante - 09 May 07, 01:43 pm
Shortening an axle - by 78calico - 09 May 07, 03:29 pm
Shortening an axle - by TJVigilante - 09 May 07, 04:01 pm
Shortening an axle - by TJVigilante - 09 May 07, 10:21 pm

Forum Jump:


Users browsing this thread: 3 Guest(s)