TJ Rubicon question...

[SHoppe715]

Just found this thread... Anyone else do this?

http://www.arcticoffroad.com/forum/showthread.php?t=346

I did it. Love it. The lockers will not disengage until some really hi speed like 35 or 45. I've never tried it. They just won't engage above 10mph. The links on that thread showed a few different leads to jump to get different behavior. I went with the simplest. 1-4 I think. I'd have to go back and look. Mine engage in HI or LO but not above 10mph. I used a toggle switch from Ace hardware that had 2 wires attached and got a rubber switch cover. I tinned the ends of the wires, smashed them flat, and just slid them in behind the leads on the locker switch. I can remove the mod any time. Mine's a manual so there was an empty switch slot right next to the AXLE LOCK switch where the autos have an OD OFF switch (I think). That's where I put the toggle. I set it to push down to engage the bypass because you push the main locker switch down too.

I'll show you when you come for that test drive.