27 Jul 08, 08:40 am
I cannot lend a hand on the 26/27th but if this gets pushed a week or better(2 weeks), I can.
You are more than welcome to use my garage for the BL/MML. We did Georges 3 weeks ago and the BL went so much faster with an air compressor and impact sockets. I think we wrapped his up in under and hour.
I also have a Dremel you can borrow. I can bring it in as far as the Fairbanks office and you can swing by and pick it up during business hours. Let me know when is good for you.
Manual lifting for the hard top, I can do.
As for the fenders, I have plaz/welder/grinders, etc. Thinkup what ya wanna to and grab some odds and ends steel from Greegers scrap pile. I have some think p[late if you want to shore up and gusset/brace it from underneath with the steel, or you could just go get some 1" .080 wall DOM and notch it lengthwise, scrap the plastic fender flares and line the outside of the remaining flat fender with the DOM. Looks sweet.
You are more than welcome to use my garage for the BL/MML. We did Georges 3 weeks ago and the BL went so much faster with an air compressor and impact sockets. I think we wrapped his up in under and hour.
I also have a Dremel you can borrow. I can bring it in as far as the Fairbanks office and you can swing by and pick it up during business hours. Let me know when is good for you.
Manual lifting for the hard top, I can do.
As for the fenders, I have plaz/welder/grinders, etc. Thinkup what ya wanna to and grab some odds and ends steel from Greegers scrap pile. I have some think p[late if you want to shore up and gusset/brace it from underneath with the steel, or you could just go get some 1" .080 wall DOM and notch it lengthwise, scrap the plastic fender flares and line the outside of the remaining flat fender with the DOM. Looks sweet.
![[-]](http://www.arcticoffroad.com/images/collapse.png)