Scrambler Rear Bumper

[AKLJ8]

Could you have cut the holes and put in some 55 watt lights then covered them with mesh for protection,don't take it wrong with the questions you did a great job that i'm sure i couldn't have done at this time.

I might do that down the road. The original design had the jeep tail lights removed with the tire on one side and the cans on the other. The design put the spindle in fron of the gas filler or out board of the jeep. So the cans were put behind the tire and the jeep lights remained. The bumper lights were kept sence the Jeep factory tail lights leeve alot to be desired...