Arctic Offroad Forums › Talk › General 4X4 v
Welding a Muffler...

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Welding a Muffler...
LowNSlowNeon
Guest
 
#3
23 Mar 06, 05:11 am
[Image: tip.jpg]

The new muffler.. may look funny to you.. but when it's mounted you can only see the tip for the most part.... and it's hard to make honduhs sound good with a big exhaust... it has a 3" tip rather than 4".. and is actually 2.5" inlet.... has the twin loop as well. (extra pipe)... The exhaust travels through the muffler two times then comes out.... Hence a quiter but yet good performing exhaust... (At idle it will sound a tad louder than stock)...
Reply


Messages In This Thread
Welding a Muffler... - by LowNSlowNeon - 23 Mar 06, 04:29 am
Welding a Muffler... - by crazy4ink - 23 Mar 06, 04:34 am
Welding a Muffler... - by LowNSlowNeon - 23 Mar 06, 05:11 am
Welding a Muffler... - by 97cheepjeep - 23 Mar 06, 05:35 am
Welding a Muffler... - by holeski - 23 Mar 06, 10:59 am
Welding a Muffler... - by jeepin_al - 23 Mar 06, 01:12 pm
Welding a Muffler... - by 28this - 23 Mar 06, 03:09 pm
Welding a Muffler... - by ChevyKev - 23 Mar 06, 04:02 pm
Welding a Muffler... - by ChevyKev - 23 Mar 06, 04:33 pm
Welding a Muffler... - by gamble71 - 23 Mar 06, 05:06 pm
Welding a Muffler... - by TJVigilante - 23 Mar 06, 06:34 pm
Welding a Muffler... - by MrsLownslow - 23 Mar 06, 08:45 pm
Welding a Muffler... - by LowNSlowNeon - 23 Mar 06, 09:52 pm
Welding a Muffler... - by naturalbornmudder - 23 Mar 06, 10:55 pm
Welding a Muffler... - by LowNSlowNeon - 23 Mar 06, 11:02 pm

Forum Jump:


Users browsing this thread: 3 Guest(s)