Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Aw4
#1
Does any one have any experiance with them. The one in project rubicant is stuck in 3rd gear in drive. If I manualy shift it 1-D it will skip 2nd and won't go into 4th. Did some reasearch on alldata seems like tranny is in safe mode. Looking for a stand alone transmission controler to bypass the OEM TCM let me know if you have any info or good web sites
Reply
#2
Definately limp-home mode.

What are you using for a computer right now?
Reply
#3
OEM TCM
Reply
#4
Try unplugging the TCM. With it unplugged you will have to use the shift lever to shift, but 1st 2nd and 3rd should work.

At least that's what a few of the older AW-4's I've played with did.
Reply
#5
Sounds like a typical failure in Jeep/Chrysler autos. I had the same issue in my old LHS and they just had to replace a ~$300 plug-in module.
Reply
#6
I haven't disconected the module but have had the battery disconected for a few days and had no change
Reply
#7
what about the shift sellector on the side of the trans, i mj that would spaz i drilled the rivets out and cleaned it. it worked fine after that.
Reply
#8
http://articles.jeepforum.com/XJ_AW4_TCU_Shift_Mod
check out this article though i would give it a try
Reply
#9
So while trying to install the switches in that article I noticed that I was missing a section of that harness from the XJ that goes from the engine harness to the body and back out and in to the tranny harness so I got on alldata and found some conector views and a extra connector and spliced them in to the new connector and then went for a road test now In (D) I have 1-4 so cool now I will make the mods in the article to manualy control what gear I am in thanks for the sugestions
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)