LED marker lights

[TJVigilante]

I have the turn signal issue worked out, no worries. What you do with the three wire pigtails to a two-wire light is put a resistor and diode on the running wire to make it dimmer, then run another diode on the signal wire without a resistor so it runs full brightness when using the turn signal. Attach both of these wires to the hot wire of the LED. The diodes are to prevent feedback through the two circuits attached to the same hot wire. if the two lights per side aren't bright enough I'll probably head to lowe's and buy a cheap amber 2" incandescent and toss it on the front grille, and run the 3/4" lights just as side markers. They should be bright enough though.