Posts: 142
Threads: 233
Thanks Received: 0 in 0 posts
Thanks Given: 0
Joined: Jan 2008
Reputation:
0
Anyone here know if you can pull a 93 toyota front axle shaft without removing the hub?
•
Posts: 82
Threads: 670
Thanks Received: 0 in 0 posts
Thanks Given: 0
Joined: Jan 2006
Reputation:
0
thats pretty hard to do.. I would just bite the bullet and pull the hub.
if you want to see if you can do it, I would try to take it out by drooping the one side of the suspension by jacking it up on the frame, and then unbolting the flange by the differential. isnt there an axle stub nut out by the wheel? that would have to come off of course as well.
The problem I would see in doing this is that the outter stub may be very hard to pull out of the unit bearing (if there is one in there) because of the friction caused by the weight of that side of the suspension.
•
Posts: 142
Threads: 233
Thanks Received: 0 in 0 posts
Thanks Given: 0
Joined: Jan 2008
Reputation:
0
On a 93 toy the are regular bearings no unit hub crap.
•
Posts: 281
Threads: 1,079
Thanks Received: 10 in 10 posts
Thanks Given: 0
Joined: May 2005
Reputation:
13
What exactly do you mean by not removing the hub? You mean take it apart and remove it? I know some you can pull the hub and all as one piece without taking it apart but don't know about the toyota.
•
Posts: 142
Threads: 233
Thanks Received: 0 in 0 posts
Thanks Given: 0
Joined: Jan 2008
Reputation:
0
If i unbolt the the top ball joint i can get it.
•
Posts: 13
Threads: 164
Thanks Received: 0 in 0 posts
Thanks Given: 0
Joined: Jan 2006
Reputation:
0
disconnect the bottom ball joint bolts , and c clip on shaft and pull out dont forget the cv on your truck also bolts to inner shaft on diff . these tend to rust on so u will need a pry bar .
•