Arctic Offroad Forums

Full Version: whosits whatsits thingys that go wheresits?
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

holeski

Engine transmission alignment dows. The two that are on the block and fit into the bell housing. What is their real name and where can I find some? Napa says no such thing. :yawn: I know you can run with out them but they are what index the tranny & motor and I rather have them then just the bolts.
Aren't they just roll pins?

akjeep

Ya gotta measure the diam and get roundstock and make your own.
Period.
Dealer only item, and I'm gonna wager you are talkin' AMC.
or you could check www.advanceadapters.com/ they might have something

holeski

J4005148 Jeep part number. $6.00 each non in the State. And it takes to long to get here.

holeski

Jackrabbit Wrote:Aren't they just roll pins?

Yes they are but Where would I find some that are as large as these are. It's for my YJ.

akdsmer

Why don't you try the two machine shops in town?

Northern...452-2004
Ports....too lazy to look that # up, plus I always deal with the guys at Northern!

holeski

I did non in the size I needed.

akdsmer

You also might try Sentry hardware.
holeski Wrote:I did non in the size I needed.

Dare I say, Rolleyes "Use a micrometer to measure your dowell!" :eek:

holeski

ChevyKev Wrote:Dare I say, Rolleyes "Use a micrometer to measure your dowell!" :eek:
I did why?

OD .560
ID .450
legnth .800
:p

holeski

Well I just reshaped the old ones. They pressed in the block fine just hope the bellhousing fit good too.