Simple! What do you want to do next to your rig? Real life though. What are you saving up to do next?
The modification sitting on your drawing board Eric. The rear bumper armor and the rock sliders.
Since the current OBA is all paid for just not installed, Ill consider that just about done. As for future mods:
Rear air tank bumper
Skid plates/rocker guards/front tube bumper
Finally finishing the axles and getting front and rear 4-links.
After that I'll consider getting a full cage, or maybe just a TBT sport cage.
Hum, rebuilding the motor....
After that.. finish installing my seats..
Then... uh probably save up for the RRO coil kit and purchase it next summer.
Beadlocks, or Yukon moly shafts with 35 spline outers and drive flanges...In reality I should do some interior work, but I'm all about stuff that actually enhances my offroad performance and not about what looks good...
Installing the 9in lift springs I got from Rob... Eventually...
I'm going to change parking lots.
Given the current rate of use and modifications, I think that counts.
Oh - add a winch before the RRO kit... but that's probably it for a while.. my bank really needs to recover.
SOFT TOP (hint hint hint ---->brian)
then tire carrier
and front stinger
TJ: full-widths
ZJ: rear bumper
Removable flares
redesign rear bumper and carrier
redesign rear hatch
finish install of corbeau seats
install harnesses
and general maintanance... been a while...
cool thing is that it all happens in a month or so...
hooking some C4 up to my truck will be my next and last mod...
How about get it running...a running rig would be the first step, hehe other then that half doors and soft top. We have some parts that need to be put on it just for looks like a new dash and light bar. Oh and I will be taking all the stickers off and getting it a new paint job...Should we keep it yellow?
Side note----not all decals just the stupid ones haha, timmae says i have to leave the "i finally got that jeep thing, now it hurts when i pee" as well as the lady outline under it!
replacing my front and rear axles....parting out the ones currently under there
Going from a BB and 31s to a 4.5 and 33s
# 1 priority - fixing the oil leak.
Hydro assist steering as I am burning up too many PS pumps.
as most folks know...
new rockers guards almost done
D44 rear axle, 4.56's and Aussie locker
then I am looking for a fuel injected motor tranny combo
ChevyKev Wrote:# 1 priority - fixing the oil leak.
That's possible? I thought it was a chevy thing?
plus I have one more mod coming soon...top secret.
1. finish rear disc brake swap on the 14 bolt
a. today, specifically, I'm going to bypass the stock LSPV and install an adjustable one from SSB. This will make the front and rear brakes isolated form each other. I'm also going to slap a coat of paint on the calipers. Some Krylon bling.
b. then I have to swap the rotors and calipers on inplace of the drums.
what is LSPV? Proportioning valve?
naturalbornmudder Wrote:what is LSPV? Proportioning valve?
Yes. Load Sensing Proportioning Valve.
next set of mods... first I need to trim the front fenders. This summer I plan on a camo paint job and 2in bodylift. All depends on if I pick up another project I'm looking at
When I leave in 07, I already have the D44/C4/D20 out of a 76 bronco. Plan a set of 4.88's with a rear locker and rebuild the front posi. That and a winch should finish her... and for once I mean it :cheers:
gamble71 Wrote:and for once I mean it
No you don't...