Arctic Offroad Forums

Full Version: 14blt vs. Dana 70
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Lets here you opinions and wisdom... I ended up with two rearends... I only need one... witch one should I go with :confused:

Parts?
Costs?
Strength?

TJVigilante

Lots of stuff out there for the 14 bolt, as I understand it not too many gear or locker options for a Dana 70. Then again, the 14 bolt has a limit on how low the gears can go due to their design.

The D70 has it in the bag for strength-to-weight ratio but it's hard to beat 35 splines from the factory. The D70 has a lesser spline count than a D60 but a much larger shaft diameter. More details here: http://www.pirate4x4.com/tech/billavista/D70/D70.htm
14 bolt are very, very common - parts readily available just about anywhere.

I don't know how the strength comparisons go - but I've seen many a 14 bolt survive where a Dana 60 didn't...
I am going to run the 14 blt
are 14 blts 30 or 35 spline? I thought they were 35 but all of the parts I seem to find are 30 spline.. for example...
http://www.ringpinion.com/PartsList.aspx...fferential

TJVigilante

Hrm, I thought they were 35 spline....ARB says 30 spline as well. According to them, a D60HD comes with 35 spline shafts in chevys.

Eh, I'm no Chevy guy...sorry if I led you in the wrong direction.
[Image: shave.gif]


This is the plan for my 14 bolt
[Image: dsc01458wt2.jpg]